9 axis AHRS E-Compass
Features
The 9 axis E-COMPASS is a new generation inertial measurement unit featuring a GNSS receiver (GPS/GLONASS/etc.) coupled with a 9 axis AHRS unit providing 3D orientation by integrating gyroscopes and data fusing with accelerometers and magnetometers.
The communication access is done through a serial RS232 NMEA protocol at user selected baud rates (4800-38400 typical); simply connect a Tx/Rx line with 5-28V power to the onboard socket.
The module supports SIRF/UBLOX NMEA input & output, standard heading HDT and the NOVASAIL proprietary messages (user manual available in the downloads section).
Other module form factors and change of spec (protocol/communication interface/etc.) can be ordered, simply contact us for any inquiry.
Spec
- Low power consumption, 250mW
- Power supply : 5V-28V, overvoltage and reverse polarity protected
- Temperature compensated
- Embedded firmware upgrade through proprietary NMEA messages
- Runtime user calibration
- 9 axis inertial measurement unit (IMU) magnetometers, accelerometers & gyroscopes data fusing with proprietary algorithm. Output complete 3D orientation : heading, yaw, pitch, roll, quaternions.
- Onboard SIRF STAR V or UBLOX GNSS chipset for precise positioning and highest sensitivity
- Windows graphical user interface (9 axis E-Compass Manager) for easy setup, monitoring and upgrades
Novasail 9 axis E-Compass Manager
An application for Windows
The Novasail E-Compass Manager software is a free application for Windows that allows you to:
- Configure and setup the unit : baud rate, message types, user calibration
- Monitor the NMEA input & output
- Upgrade the embedded firmware
- Monitor the NMEA input & output